Vehicle Control Module (V/C-Module) Inspection (MRCC System): Notes
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)
- Remove the following parts:
- Front scuff plate (RH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
- Front side trim (RH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
- Connect the negative battery cable.
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).
- If the system does not work normally even though the Inspection item(s) or related wiring harnesses do not have any malfunction, inspect the vehicle control module (V/C-module) using the on-board diagnostic system.
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).