Rear Door Quarter Glass Removal/Installation: Notes
- Fully lower the rear door glass.
- Disconnect the negative battery cable. (See
NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.)
- Remove the rear door trim. (See
REAR DOOR TRIM REMOVAL/INSTALLATION
.)
- Remove the service hole cover arrow (1) shown in the figure.
CAUTION:
- When removing service hole cover, remove it while gradually stripping the butyl rubber. Otherwise service hole cover may be deformed.
Courtesy of MAZDA MOTORS CORP.
- Partially peel back rear door weather strip.
- Remove screw.
Courtesy of MAZDA MOTORS CORP.
- Remove bolts.
Courtesy of MAZDA MOTORS CORP.
- Partially peel back the rear door glass run channel. (See
REAR DOOR GLASS RUN CHANNEL INSTALLATION NOTE .)
Courtesy of MAZDA MOTORS CORP.
- Pull the glass guide in the direction of the arrow (2) shown in the figure, then remove the glass guide direction of the arrow (3) shown in the figure. (See
GLASS GUIDE INSTALLATION NOTE .)
Courtesy of MAZDA MOTORS CORP.
- Pull the rear door glass run channel in the direction of the arrow (4) then remove the rear door glass run channel. (See
REAR DOOR GLASS RUN CHANNEL INSTALLATION NOTE .)
Courtesy of MAZDA MOTORS CORP.
- Slide the rear door quarter glass and rear door quarter glass guide as a single unit in the direction of the arrow (5) shown in the figure.
Courtesy of MAZDA MOTORS CORP.
- Remove the rear door quarter glass and rear door quarter glass guide as a single unit in the direction of the arrow (6) shown in the figure.
- Pull the rear door quarter glass guide in the direction of the arrow (7) and remove the rear door quarter glass.
- Install in the reverse order of removal.
Courtesy of MAZDA MOTORS CORP.