Diagnostic Procedure

DTC B13C3:04 DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	INSPECT LF CONTROL UNIT Inspect the LF control unit. (See LF CONTROL UNIT INSPECTION .) Is the LF control unit normal?	Yes	Go to the next step.
1		No	Replace the LF control unit, then go to the next step. (See LF CONTROL UNIT REMOVAL/INSTALLATION .)
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the advanced keyless entry system using the M-MDS. (See CLEARING DTC [ADVANCED KEYLESS ENTRY SYSTEM] .) Retrieve the advanced keyless entry system DTCs using the M-MDS. (See DTC INSPECTION [ADVANCED KEYLESS ENTRY SYSTEM] .) Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the start stop unit. (See START STOP UNIT REMOVAL/INSTALLATION .) Go to the next step.
2		No	Go to the next step.
3	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [ADVANCED KEYLESS ENTRY SYSTEM] .)
3		No	DTC troubleshooting completed.