Common Specifications & Procedures
MX-5 COMMON SPECIFICATIONS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | HVAC - TECHNICAL DATA (HEATER, VENTILATION & AIR CONDITIONING) -- MX-5 MIATA | ||
| Torque | See Torque Specifications in appropriate graphics under HVAC - BASIC SYSTEM -- MX-5 MIATA . | ||
| Axle Nut/Hub Nut (Rear) | 173-203 Ft. Lbs. (235-276 N.m) | ||
| Battery | BATTERY INSPECTION [LF] | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF AIR BLEEDING |
||
| Disc Brakes | |||
| Service Specifications | BRAKES TECHNICAL DATA | ||
| Torque | See Torque Specifications in appropriate graphics under CONVENTIONAL BRAKE SYSTEM . | ||
| Charging | |||
| Generator | GENERATOR INSPECTION [LF] | ||
| Torque | See Torque Specifications in appropriate graphics under GENERATOR REMOVAL/INSTALLATION [LF] . | ||
| Drive Belts | |||
| Adjustment | DRIVE BELT INSPECTION [LF] | ||
| Belt Routing | See appropriate graphics under DRIVE BELT INSPECTION [LF] . | ||
| Engine Cooling | |||
| General Service Specifications | N/A | ||
| Radiator Cap Pressure | 17.8 psi (122.6 kPa, 1.25 kgf/cm2 ) |
||
| Thermostat R & I | N/A | ||
| Water Pump R & I | N/A | ||
| Engine Mechanical | |||
| 2.0L 4-Cyl. | |||
| Compression | COMPRESSION INSPECTION [LF] | ||
| Oil Pressure | 49.0-85.8 psi (337-591 kPa; 3.44-6.03 kg/cm2 ) at 3, 000 RPM. | ||
| Overhaul | ENGINE TECHNICAL DATA [LF] k | ||
| Torque | See Torque Specifications in procedure text under MECHANICAL (LF) -- MX-5 MIATA . | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 80-86 Ft. Lbs. (108-116 N.m) | ||
| Fuel System | |||
| Pressure Specification | 54.4-65.2 psi (375-450 kPa; 3.83-4.58 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL LINE PRESSURE INSPECTION [LF] | ||
| Fuel Filter Location | Fuel filter is attached to fuel pump unit. | ||
| Fuel Filter R & I | FUEL PUMP UNIT REMOVAL/INSTALLATION [LF] | ||
| Ignition | |||
| Firing Order & Cylinder Identification | N/A | ||
| Ignition Wires (Resistance) | The 2.0L uses coil-on-plug ignition. | ||
| Ignition Wires (Routing) | The 2.0L uses coil-on-plug ignition. | ||
| Spark Plug | |||
| 2.0L 4-Cyl. (LFD) (NGK L3G2 18 110, L3Y1 18 110) | |||
| Gap | 0.050-0.057 in. (1.25-1.45 mm) | ||
| Torque | 8-10 Ft. Lbs. (10-14 N.m) | ||
| Starting | |||
| Starter | STARTER INSPECTION [LF] | ||
| Torque | See Torque Specifications in appropriate graphics under STARTER REMOVAL/INSTALLATION [LF] . | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | FRONT WHEEL ALIGNMENT | ||
| Rear | REAR WHEEL ALIGNMENT | ||
| Torque | |||
| Front | See Torque Specifications in text under FRONT WHEEL ALIGNMENT . | ||
| Rear | See Torque Specifications in text and appropriate graphics under REAR WHEEL ALIGNMENT . | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 65-87 Ft. Lbs. (88-118 N.m) | ||