Without using M-MDS

Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION .)
Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
Short the check connector terminal F/P to ground using a jumper wire.

Fig 1: Locating Check Connector
Courtesy of MAZDA MOTORS CORP.

Fig 2: Check Connector Terminal F/P

Courtesy of MAZDA MOTORS CORP.

Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
Turn the ignition switch to the ON position to operate the fuel pump.
Verify that there is no fuel leakage from the pressurized parts.
Standard

There shall be no leakage after 5 min.
In the case of fuel leakage, replace the following components and then do the recheck by the fuel leakage checking procedure.
- If there is leakage, replace the fuel hoses and clips.
- If there is damage on the seal on the fuel pipe side, replace the fuel pipe.