LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Electrical >> Horns >> Instrumentation/Driver Info >> Instrument Cluster Configuration

Instrument Cluster Configuration

NOTE:
  • If all the following conditions are met, the odometer data (total traveled distance) in the previous instrument cluster is automatically transferred to a new instrument cluster during the configuration, if any of the conditions are not met, odometer-data transfer cannot be performed.

    Previous instrument cluster 

    • No malfunction (Configuration data can be read using the M-MDS).

    New instrument cluster 

    • Odometer display is less than 100 km 
    • Odometer has no malfunction
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Module Programming".
    • When using the PDS (Pocket PC)
      1. Select "Programming".
      2. Select "Module Programming".
  3. Select "Programmable Module Installation".
  4. Select "IC" and perform procedures according to directions on the M-MDS screen.
    • If odometer data is to be transferred to a new instrument cluster, perform the following procedure:
      Fig 1: DLC-2 Location
      G06149185Courtesy of MAZDA MOTORS CORP.
      1. Select "Programmable Parameters" from the menu.
      2. Select "Odometer Write", and perform the procedure following the screen.
        NOTE:
        • During the odometer data writing procedure, As-Built Data (VIN and Vehicle Data) input is requested. Obtain the As-Built Sheet for the vehicle, and input the necessary data.
  5. Retrieve DTCs using the M-MDS and verify that there is no DTC present.
scientia non olet · About LEMON Manuals