No. 5 Programming Procedure Due to Keyless Control Module Replacement: Procedure

Fig 1: Valid Key

Courtesy of MAZDA MOTORS CORP.

KEYLESS CONTROL MODULE PROGRAMMING PROCEDURE CHART

Step	Procedure	Action after procedure
1	REPLACE KEYLESS CONTROL MODULE  Refer to KEYLESS CONTROL MODULE REMOVAL/INSTALLATION  to perform keyless control module replacement. (See KEYLESS CONTROL MODULE REMOVAL/INSTALLATION )	Go to the next step.
2	PERFORM PARAMETER RESET  Connect the M-MDS to the DLC-2. (See M-MDS CONNECTING PROCEDURE ) Turn the ignition switch to the ON position using a valid key. NOTE: Although the security light remains illuminated and DTC 15 is displayed after approx. 1 min  , continue to perform the procedure as indicated. Verify that the keyless warning light illuminates for approx. 3 s  , and then turns off. After vehicle identification, select the following from the M-MDS initial screen. Using an IDS (laptop PC) Select "Body". Select "Security". Select "PATS Functions". Using a PDS (pocket PC): Select "Programming". Select "PATS Functions". Then, select an item from the screen menu. Parameter Reset Perform the security access according to the directions on the M-MDS screen. Select the replaced parts "RKE" according to the directions on the M-MDS screen. CAUTION: At this time, do not select the other parts from the M-MDS menu. Verify that the PATS function menu is displayed again on the M-MDS screen.	Go to the next step.
3	CLEAR IGNITION KEY ID NUMBERS  Select "Ignition Key Code Erase and Program" from the M-MDS screen menu. Clear the ignition key ID number according to the directions on the M-MDS.	Go to the next step.
4	PERFORM IGNITION KEY ID NUMBER PROGRAMMING  Program two keys according to the directions on the M-MDS. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)". Turn the ignition switch to the LOCK position. Turn the ignition switch to the ON position. Verify that the security light illuminates for approx. 3 s  , and then turns off. Turn the ignition switch to the LOCK position. Disconnect the M-MDS from the DLC-2.	Go to the next step.
5	VERIFY PROGRAMMING IS PERFORMED CORRECTLY  Verify that the engine can be started with all the keys. Can the engine be started?	Yes	Procedure is completed
		No	Perform the corresponding DTC inspection to repair the malfunctioning part.