Continuity Inspection

Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
To remove the service hole cover, remove the following parts:
1. Second-row seat (See SECOND-ROW SEAT REMOVAL/INSTALLATION .)
2. Edge cover (See LONG SLIDER REMOVAL/INSTALLATION .)
3. Long slider cover (See LONG SLIDER REMOVAL/INSTALLATION .)
4. Rear heat duct No. 3 (See REAR HEAT DUCT COMPONENT REMOVAL/INSTALLATION .)
5. Service hole cover (See FUEL PUMP UNIT REMOVAL/INSTALLATION .)
Disconnect the fuel pump unit connector.
Inspect for continuity between fuel pump unit connector terminals B and D.
- If there is no continuity, replace the fuel pump unit. (See FUEL PUMP UNIT REMOVAL/INSTALLATION .)
- If as specified carry out the "Circuit Open/Short Inspection". (See CIRCUIT OPEN/SHORT INSPECTION .)
  
  Fig 1: Identifying Fuel Pump Unit Connector Terminals
  Courtesy of MAZDA MOTORS CORP.