LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> CX-5 Touring, 4D Utility, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System/Washer System >> Washer Fluid-Level Sensor Removal/Installation

Washer Fluid-Level Sensor Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Set the front over fender aside. (See FRONT OVER FENDER REMOVAL/INSTALLATION .)
  3. Set the mudguard (RH) aside. (See MUDGUARD REMOVAL/INSTALLATION .)
  4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION .)
  5. Disconnect the washer fluid-level sensor connector.
  6. Remove the washer fluid-level sensor.
    NOTE:
    • If the washer fluid-level sensor is removed with washer fluid in the washer tank, the washer fluid may leak out. When removing the washer fluid-level sensor from the washer tank, place a container under the washer tank to collect washer fluid, and perform the procedure.
  7. Remove the grommet.
  8. Install in the reverse order of removal.
    Fig 1: Identifying Washer Fluid-Level Sensor Components
    G09077584Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals