Blind Spot Monitoring (BSM) Control Module Inspection: Notes

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Remove the rear combination light. (See REAR COMBINATION LIGHT REMOVAL/INSTALLATION .)
Remove the rear bumper. (See REAR BUMPER REMOVAL/INSTALLATION .)
Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Verify that the voltages of each of the terminals are as indicated in the terminal voltage table (reference).
- If the voltage is not as specified in the terminal voltage table (reference), inspect the parts under Inspection item(s).
  - If the system does not operate normally even though the inspection items are normal, replace the BSM control module (RH) or BSM control module (LH).