DTC P0733:00: Notes

DTC P0733:00	Gear 3 incorrect ratio
DETECTION CONDITION	Under the following condition, input shaft and output shaft rotation ratio is 2.157 or more Gear position is 3GR Under the following conditions, input shaft and output shaft rotation ratio is 1.344-1.644 Gear position is 3GR Vehicle speed is 27 km/h {17 mph} or more TCC operation is off Under the following conditions, input shaft and output shaft rotation ratio is 0.863 or less Gear position is 3GR Vehicle speed is 44 km/h {28 mph} or more TCC operation is off Diagnostic support note The check engine light does not illuminate. The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is not available. FREEZE FRAME DATA is not available. The DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	Inhibits feedback control
POSSIBLE CAUSE	Deteriorated ATF ATF level low Solenoid valve malfunction Pressure control solenoid A Shift solenoid A Shift solenoid C Line pressure malfunction Stall speed malfunction Forward clutch slipping 3-4 clutch slipping Primary control valve body malfunction TCM malfunction
SYSTEM WIRING DIAGRAM	-