LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 5 Touring >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Cruise Control Switch Inspection >> Two-Step Deployment Control System

Two-Step Deployment Control System

  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION .)
  2. Disconnect the negative battery cable and wait for 1 min or more  .
  3. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
  4. Disconnect the clock spring connector (part wiring harness-side).
  5. Inspect for resistance and continuity between clock spring connector terminals 5D and 5F (part wiring harness-side) using a tester.
    Fig 1: Cruise Control Switch Circuit Diagram (5D And 5F)
    G08150306Courtesy of MAZDA MOTORS CORP.
    Fig 2: Identifying Cruise Control Switch Connector Terminals (5D And 5F)
    G08150307Courtesy of MAZDA MOTORS CORP.
    Switch condition Resistance (ohm)
    Cruise OFF switch held at on Continuity
    CANCEL switch held at on 118.8-121.2
    SET (-) switch held at on 297.0-303.0
    SET (+) switch held at on 594.0-606.0
    RESUME switch held at on 1, 098.9-1, 121.1
    Cruise ON switch held at on 2, 088.9-2, 131.1
    Neutral 4, 266.9-4, 353.1
  6. Apply battery positive voltage to clock spring terminal 5O (part wiring harness-side) and terminal 5E (part wiring harness-side) to ground.
    Fig 3: Applying Battery Voltage And Ground To Clock Spring Terminal 5O, 5E
    G08150308Courtesy of MAZDA MOTORS CORP.
  7. Verify that the LED illuminates.
scientia non olet · About LEMON Manuals