Flywheel Installation Note
- Clean the crankshaft thread holes.
- Install the flywheel and the plate to the crankshaft, and temporarily tighten a new lock bolts.
- Hold the flywheel using the SST.
- Tighten the lock bolts completely in the order shown in the figure in the following 3 steps.
Tightening torque
Step 1: 46-54 N.m {4.7-5.5 kgf.m, 34-39 ft.lbf}
Step 2: 76-84 N.m {7.8-8.5 kgf.m, 57-61 ft.lbf}
Step 3: 108-116 N.m {11.1-11.8 kgf.m, 80-85 ft.lbf}