LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 3 SV, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Airbag System (Two-Step Deployment Control System)) >> Passenger-Side Air Bag Module Removal/Installation [Two-Step Deployment Control System] >> Screw installation Note

Screw installation Note

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The passenger-side air bag module fixing screws are set in the back side of the dashboard. Affix packing tape to a Phillips screwdriver so that the screws do not fall off while performing the work.
  1. Insert a Phillips screwdriver into the screw groove and fix it with packing tape.
  2. Tighten the screw halfway.
  3. Remove the packing tape.
    CAUTION:
    • If the packing tape is left in the vehicle when tightening the screw, it may become a source of noise. When tightening the Screw, remove the packing tape so that it does not remain in the vehicle.
    Fig 1: Identifying Passenger-Side Air Bag Module Fixing Screws
    G09076057Courtesy of MAZDA MOTORS CORP.
  4. Tighten the screw completely.
scientia non olet · About LEMON Manuals