LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 3 SV, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Airbag System (Two-Step Deployment Control System)) >> Crash Zone Sensor Removal/Installation [Two-Step Deployment Control System] >> Connector Disconnect Note

Connector Disconnect Note

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Press the area (1) indicated by the arrow and slide it as shown in the figure (2).
    Fig 1: Disconnecting Crash Zone Sensor Connector
    G09076067Courtesy of MAZDA MOTORS CORP.
  2. Lift up the location shown in the figure using a tape-wrapped flathead screwdriver (3) and disconnect the connector (4).
scientia non olet · About LEMON Manuals