LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2014 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Conventional Brake System) >> Power Brake Unit Inspection >> Using SST >> Pre-inspection preparation

Pre-inspection preparation

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the brake pipe from the brake hose.
  2. Remove the clip.
  3. Remove the brake hose from the bracket.
  4. Detach the brake pipe from the pipe holder.
    Fig 1: Identifying Brake Pipe, Pipe Holder And Clip
    G09785817Courtesy of MAZDA MOTORS CORP.
  5. Install the SSTs  to the brake pipe as shown in the figure.
  6. Bleed the brake line and the SSTs  of air. Bleed the air form the SSTs  using bleeder screw A.
  7. Install the pedal force gauge to the brake pedal.
  8. Connect the vacuum gauge to the vacuum line.
    Fig 2: Connecting Vacuum Gauge To Vacuum Line
    G09785818Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals