Action for Non-repeatable Malfunction

If the malfunction does not recur, verify the malfunction cause by performing the following actions:
1. Verify that a DTC has been recorded in the memory using the M-MDS. (See ON-BOARD DIAGNOSIS .)
2. Perform a simulation test in the simulation mode based on the repair order form, record the data at that time, and detect the malfunction cause.
3. Shake the wiring harness or connector of the electrical component which is suspected to be the cause of the malfunction, and inspect for the occurrence of any malfunction or DTCs.
  
  Fig 1: Shaking Electrical Component Connector
  Courtesy of MAZDA MOTORS CORP.
4. Inspect the female terminals for poor connection.
  
  Fig 2: Inspecting Connector Female Terminals Poor Connection
  Courtesy of MAZDA MOTORS CORP.