Transfer Installation Note

Push the engine forward so that the front side of the transfer faces downward, then install the transfer.
Install the transfer installation bolts.
Tightening torque

90-100 N.m {9.2-10.1 kgf.m, 66.4-73.7 ft.lbf}
NOTE:
- When replacing bolt C on the crossmember side, always replace it with a bolt of the same size as the removed one.
  
  Fig 1: Installing Transfer
  Courtesy of MAZDA MOTORS CORP.
Tighten the No. 1 engine mount bolt C at the specified torque.
Tightening torque

105-132 N.m {11-13 kgf.m, 78-97 ft.lbf}

Fig 2: Locating No. 1 Engine Mount Bolt C
Courtesy of MAZDA MOTORS CORP.
Rotate the front stabilizer to the rear to set it in its original position.

Fig 3: Rotating Front Stabilizer
Courtesy of MAZDA MOTORS CORP.