LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> CX-5 Touring, FWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Lock System >> Front Door Lock Actuator Inspection

Front Door Lock Actuator Inspection

  1. Perform the front door glass removal preparation. (See FRONT DOOR GLASS REMOVAL/INSTALLATION ).
  2. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
  3. Remove the following parts:
    1. Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION ).
    2. Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION ).
    3. Front door glass (See FRONT DOOR GLASS REMOVAL/INSTALLATION ).
    4. Front door module panel (See FRONT DOOR MODULE PANEL REMOVAL/INSTALLATION ).
    5. Front door key cylinder (See FRONT DOOR KEY CYLINDER REMOVAL/INSTALLATION ).
    6. Front door latch and lock actuator (See FRONT DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION ).
  4. Apply battery positive voltage and connect the ground to the front door lock actuator terminals as indicated in the table below and verify the operation condition.
    FRONT DOOR LOCK ACTUATOR B+ Terminal Ground Terminal Operation
    LH A G LOCK
    G A UNLOCK
    RH K E LOCK
    E K UNLOCK
    Fig 1: Checking Front Door Latch And Lock Actuator
    G09077031
    • If not as indicated in the table, replace the front door latch and lock actuator.
scientia non olet · About LEMON Manuals