PID/Data Monitor Table [Two-Step Deployment Control System]
| PID name (definition) | Unit/Operation | Operation Status (Reference) |
|---|---|---|
| AB_WL (Air bag system warning light status) |
Lamp_Off/Lamp_On/Plant_Mode/Unknown |
|
| B_SW_P_FLT (Passenger-side buckle switch malfunction status) |
O.K./FAULT |
|
| D_SP_S_FLT (Seat track position sensor malfunction status) |
O.K./FAULT |
|
| D_SP_S_ST (Seat track position sensor state) |
Rearward/Forward |
|
| OCS_DTC_CLR (Seat weight sensor DTC cleared status) |
Starting/Normal End/In Process/OCS Fault | Fault information cleared at seat weight sensor |
| P_OCS_ST (Seat weight sensor status) |
Empty/SMALL/Indeterminate/LARGE | Occupant classification status determined by seat weight sensor |
| P_WEIGHT (Seat weight sensor measured weight of passenger) |
Kg | Display of load (body weight) on passenger-side seat |
| RES_C_AB_D (Driver-side curtain air bag module resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| RES_C_AB_P (Passenger-side curtain air bag module resistance nominal) |
ohm | Continuous:0.81-6.42 ohms |
| RES_F_AB1_D (Driver-side air bag module (inflator No.1) resistance nominal) |
ohm | Continuous: 0.99-6.42 ohms |
| RES_F_AB1_P (Passenger-side air bag module (inflator No.1) resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| RES_F_AB2_D (Driver-side air bag module (inflator No.2) resistance nominal) |
ohm | Continuous: 0.99-6.42 ohms |
| RES_F_AB2_P (Passenger-side air bag module (inflator No.2) resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| RES_PCD_BAR (Poorly connected detector bar terminals resistance nominal (all of SAS control module connectors)) |
ohm |
|
| RES_S_AB_D (Driver-side side air bag module resistance nominal) |
ohm | Continuous: 0.81-9.85 ohms |
| RES_S_AB_P (Passenger-side side air bag module resistance nominal) |
ohm | Continuous: 0.81-9.85 ohms |
| RES_SB_LP_D (Driver-side lap pre-tensioner seat belt resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| RES_SB_LP_P (Passenger-side lap pre-tensioner seat belt resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| RES_SB_P_D (Driver-side pre-tensioner seat belt resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| RES_SB_P_P (Passenger-side pre-tensioner seat belt resistance nominal) |
ohm | Continuous: 0.81-6.42 ohms |
| SEAT_B_D (Driver-side buckle switch status) |
Unbuckled/Buckled |
|
| VPWR_IGA (SAS control module power voltage) |
V | Ignition switch is at ON: IG1 voltage |