Washer Motor Inspection

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
Set the front over fender aside. (See FRONT OVER FENDER REMOVAL/INSTALLATION ).
Set the mudguard (RH) aside. (See MUDGUARD REMOVAL/INSTALLATION ).
Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION ).
Disconnect the washer motor connector from the washer motor.
Disconnect the windshield washer hose from the washer motor.
Disconnect the rear washer hose from the washer motor.
WARNING:
- Water sprayed on the battery and ground could cause electrocution. When performing the washer motor inspection, prepare a container to collect washer fluid and be careful not to spray washer fluid.
After connecting washer motor terminal A to the positive battery terminal, and terminal B to ground, verify that washer fluid sprays from the front side of the washer motor.

Fig 1: Connecting Washer Motor Terminal A To Positive Battery Terminal And Terminal B To Ground
- If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION ).
  
  Fig 2: Identifying Washer Motor Connector (Front)
After connecting washer motor terminal B to the positive battery terminal, and washer motor terminal A to ground, verify that washer fluid sprays from the rear side of the washer motor.

Fig 3: Connecting Washer Motor Terminal B To Positive Battery Terminal And Washer Motor Terminal A To Ground
- If there is any malfunction, replace the washer motor. (See WASHER MOTOR REMOVAL/INSTALLATION ).
  
  Fig 4: Identifying Washer Motor Connector (Rear)