LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> CX-5 Sport, AWD >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic (Engine Controls) - Introduction, After Repair Procedure, DTC Table >> After Repair Procedure [SKYACTIV-G 2.0]

After Repair Procedure [SKYACTIV-G 2.0]

  1. Switch the ignition to off.
  2. Connect the M-MDS to the DLC-2.
  3. Switch the ignition ON (engine off).
  4. Verify the DTC according to the directions on the M-MDS screen.
    • Press the clear button on the DTC screen to clear the DTC.
  5. Switch the ignition off (LOCK) and continue it for 30 s or more  .
    CAUTION:
    • Always switch the ignition off (LOCK) after clearing the DTC.
    • If the engine is accidentally started, reset the battery.
  6. Switch the ignition ON (engine on).
  7. Verify all accessory loads are off.
  8. Start the engine and maintain the engine speed at 2,800-3,200 rpm  until the cooling fan starts running (for A/F sensor and HO2S activation).
  9. When the cooling fan starts running, idle the engine.
  10. Maintain the idle status for 30 s or more  after the cooling fan has stopped (for fuel learning).
  11. Perform the DTC inspection again and verify that no DTCs are stored. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0] ).
  12. Switch the ignition to off.
  13. Disconnect the M-MDS to the DLC-2.
scientia non olet · About LEMON Manuals