DTC B108B:29 [Advanced Keyless Entry And Push Button Start System]: Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DETECTION CONDITION AND POSSIBLE CAUSE
| DETECTION CONDITION |
Mismatch state of push button start 1 and 2 |
| POSSIBLE CAUSE |
- Connector or terminal malfunction
- Short to ground in wiring harness between push button start terminal A and keyless control module terminal 2J
- Short to ground in wiring harness between push button start terminal B and keyless control module terminal 2K
- Short to power supply in wiring harness between push button start terminal A and keyless control module terminal 2J
- Short to power supply in wiring harness between push button start terminal B and keyless control module terminal 2K
- Push button start malfunction
- Open circuit in wiring harness between push button start terminal A and keyless control module terminal 2J
- Open circuit in wiring harness between push button start terminal B and keyless control module terminal 2K
- Keyless control module malfunction
|
 Courtesy of MAZDA MOTORS CORP.
|