LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 6 i Touring Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 561 (Power Systems) >> Relay Block Removal/Installation [With Advanced Keyless Entry And Push Button Start System]

Relay Block Removal/Installation [With Advanced Keyless Entry And Push Button Start System]

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable
  2. Remove the lower panel. See LOWER PANEL REMOVAL/INSTALLATION .
  3. Remove the knee bolster See KNEE BOLSTER REMOVAL/INSTALLATION .
  4. Remove the wiring harness clip
  5. Remove the clips
    Fig 1: Identifying Wiring Harness Clip And Clips
    G06205732Courtesy of MAZDA MOTORS CORP.
  6. Remove the relay block
    Fig 2: Identifying Relay Block
    G06205733Courtesy of MAZDA MOTORS CORP.
  7. Disconnect the connectors
  8. Install in the reverse order of removal.
Fig 3: Identifying Relay Block And Connector
G06205734Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals