Brake override system operation inspection

NOTE:

If the brake override system operates normally after performing the following inspection, the PCM detects DTC P2299:00.

Start the engine and run it is idling.
Verify that the engine speed becomes less than 1,100 rpm under the following conditions.
- Neutral (MTX)
- P, or N position (ATX)
- Engine speed of 1,150 rpm or more other than idle
- Brake pedal depressed
  - If the engine speed becomes less than 1,100 rpm , clear the PCM DTC using the M-MDS. (System operation is normal.)
  - If the engine speed does not become less than 1,100 rpm , inspect for the following parts, then repair or replace the malfunctioning part:
    - APP sensor (See ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION .)
    - Neutral switch (MTX) (See NEUTRAL SWITCH INSPECTION .)
    - Clutch switch (MTX) (See CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION .)
    - TR switch (ATX) (See TRANSAXLE RANGE (TR) SWITCH INSPECTION .)
    - Brake switch No.1 (See BRAKE SWITCH INSPECTION .)
    - Brake switch No.2 (See BRAKE SWITCH INSPECTION .)
    - Communication between PCM and TCM (ATX) (See FOREWORD [MULTIPLEX COMMUNICATION SYSTEM] .)