LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 3 Mazdaspeed, 2.3L Eng VIN 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 604 (Security System And Locks System) >> Trunk Lid Latch Switch Inspection

Trunk Lid Latch Switch Inspection

WARNING: This page is about a different car, the 2012 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.0, MZR 2.5] .) (See BATTERY REMOVAL/INSTALLATION [SKYACTIV-G 2.0] .)
  2. Remove the trunk lid trim. (See TRUNK LID TRIM REMOVAL/INSTALLATION .)
  3. Remove the trunk lid latch and lock actuator. (See TRUNK LID LATCH AND RELEASE ACTUATOR REMOVAL/INSTALLATION .)
  4. Press the latch in using a flathead screwdriver to inspect the latch lever condition.
    Fig 1: Pressing Latch Using Flathead Screwdriver
    G08158839
  5. Verify that the continuity is as indicated in the table.
    Fig 2: Trunk Lid Latch Switch Terminal Continuity Chart
    G08158840
    • If not as indicated in the table, replace the trunk lid latch and release actuator
    Fig 3: Trunk Lid Latch Switch And Terminal Identification
    G08158841
scientia non olet · About LEMON Manuals