LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 3 Mazdaspeed, 2.3L Eng VIN 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 545 (Lighting System) >> Steering Angle Sensor Initialization Procedure

Steering Angle Sensor Initialization Procedure

WARNING: This page is about a different car, the 2012 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If the following servicing is to be done, perform the steering angle sensor initialization procedure.
    • The negative battery cable is disconnected
    • Battery is replaced
    • A fuse (ROOM) is removed
    • Main fuse is replaced
    • The steering angle sensor connector is disconnected
    • Steering angle sensor is replaced
    • Steering angle sensor connector is disconnected
    • BCM connector is disconnected
    • BCM is replaced
  1. Inspect the wheel alignment, inflation pressure, and the installation condition of the steering wheel.
    • If there is any malfunction, adjust the applicable part.
  2. Start the engine.
  3. Turn the steering wheel to full right lock, then turn it to full left lock.
    NOTE:
    • The steering wheel can be turned first to the left or right.
    • If the steering wheel is turned in the opposite direction before it locks, the correct steering angle will not be stored in memory.
  4. Switch the ignition OFF (LOCK).
scientia non olet · About LEMON Manuals