LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2013 >> 3 Mazdaspeed, 2.3L Eng VIN 3 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System On-Board Diagnostic (MZR 2.3 DISI Turbo) - Introduction, After Repair Procedure, DTC Table >> On-Board Diagnostic Test >> On-Board System Readiness Tests Access Procedure

On-Board System Readiness Tests Access Procedure

  1. Connect the M-MDS (IDS) to the DLC-2.
    Fig 1: Identifying DLC-2 Location
    G08156153Courtesy of MAZDA MOTORS CORP.
  2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
    1. Select "Powertrain".
    2. Select "OBD Test Modes".
    3. Select "Mode 1 Powertrain Data".
    4. Select "PCM".
  3. Then, select the "***SUP" and "**EVAL" PIDs in the PID selection screen.
  4. Monitor those PIDs and check it system monitor is completed.
    NOTE:
    • If the on-board system readiness tests are not completed the PCM stores DTC P1000.
scientia non olet · About LEMON Manuals