| 1 |
REPLACE INSTRUMENT CLUSTER
Refer to INSTRUMENT CLUSTER REMOVAL/INSTALLATION
to perform instrument cluster replacement and configuration.
(See
INSTRUMENT CLUSTER REMOVAL/INSTALLATION
).
(See
INSTRUMENT CLUSTER CONFIGURATION
). |
Go to the next step. |
| 2 |
PERFORM PARAMETER RESET
- Connect the M-MDS to the DLC-2.
(See
M-MDS CONNECTING PROCEDURE ).
- Switch the ignition ON using a key (The key can be either the valid key).
NOTE:
- Although the security light remains illuminated and DTC 15 is displayed after approx. 1 min
, continue to perform the procedure as indicated.
- After the vehicle is identified, select "Body", then "Security", then "PATS function" from the initial screen of the IDS.
- Then, select an item from the screen menu.
item
- Perform the security access according to the directions on the M-MDS screen.
- Select replaced parts "IC" according to the directions on the M-MDS screen.
CAUTION:
- At this time, do not Select other parts from the M-MDS menu.
- Verify that the PATS function menu is displayed again on the M-MDS screen.
|
Go to the next step. |
| 3 |
CLEAR IGNITION KEY ID NUMBERS
- Select "Ignition Key Code Erase and Program" from the M-MDS screen menu.
- Clear the ignition key ID number according to the directions on the M-MDS.
|
Go to the next step. |
| 4 |
PERFORM IGNITION KEY ID NUMBER PROGRAMMING
- Program two keys according to the directions on the M-MDS.
- After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)".
- Switch the ignition to off.
- Switch the ignition to ON.
- Verify that the security light illuminates for approx. 3 s, and then turns off.
- Switch the ignition to off.
- Disconnect the M-MDS from the DLC-2.
|
Go to the next step. |
| 5 |
VERIFY PROGRAMMING IS PERFORMED CORRECTLY
- Verify that the engine can be started with all the keys.
- Can the engine be started?
|
Yes |
Procedure is completed |
| No |
Perform the corresponding DTC inspection to repair the malfunctioning part. |