LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2012 >> MX-5 Miata Touring, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> General Procedures [Brake System) >> General Procedures (Brake) >> Steering Angle Sensor Initialization Procedure

Steering Angle Sensor Initialization Procedure

WARNING:
  • Unless the initialization procedure of the steering angle sensor is completed, the DSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC operation if the power supply to the steering angle sensor has been cut off due to disconnection of the steering angle sensor connector or negative battery cable, or any other cause.
NOTE:
  • The initialization value of the steering angle sensor is stored using the battery power supply. Therefore, the battery power supply of the steering angle sensor is cut and the stored initialization value is cleared when any of the following items are performed.
    • Negative battery cable disconnection
    • Steering angle sensor connector disconnection
    • Fuse (ROOM 15A) removal
    • Wiring harness disconnection between battery and steering angle sensor connector
  1. When replacing or removing the following parts, perform the initialization procedure. (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE .)
    • Negative battery cable disconnection
    • Steering angle sensor connector disconnection
    • Fuse (ROOM 15A) removal
    • Wiring harness disconnection between battery and steering angle sensor connector
scientia non olet · About LEMON Manuals