No. 4 After Engine Start, Electrical Devices Do Not Operate [Advanced Keyless Entry And Push Button Start System]: Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
AFTER ENGINE START, ELECTRICAL DEVICES DO NOT OPERATE DESCRIPTION AND POSSIBLE CAUSES
| 4 |
After engine start, electrical devices do not operate |
| DESCRIPTION |
- Possible cause related to non-operation of electrical devices (such as blower motor, rear wiper) with ignition switched to IG ON (IG2), after engine start.
|
| Possible Causes |
- Open or short circuit in wiring harness between battery and relay block (IG2 relay) and each part
- Fuse burnt out (short to ground in related wiring harness)
- Open circuit in wiring harness between keyless control module and relay block (IG2 relay)
- Block relay (IG2 relay) malfunction (stuck open)
- Keyless control module malfunction
|