No.4 Programming Procedure After Simultaneous Replacement of Immobilizer System-related Parts (PCM, Keyless Control Module): Notes
CAUTION:
- The engine cannot be started if any step or procedure is skipped. Perform all procedures in the order of the steps.
NOTE:
- If the keyless control module is replaced, complete the configuration before performing the following menu.
- If the PCM is replaced, complete the configuration before performing the following menu.
- When replacing the keyless control module, remove the valid keys and the valid advanced keys from the vehicle (keep them 1 m or more from the vehicle) and switch the ignition ON according to the directions on the M-MDS (IDS) screen. Select, "There is no programmed ignition key and programmed advanced key" from the M-MDS (IDS) screen.CAUTION:
- If the ignition is switched ON by selecting "FORCED IGNITION ON", the engine cannot be started.
- Although the security light or the keyless warning light illuminates or flashes, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
CAUTION:
M-MDS menu
- (1): Parameter Reset
- (2): Ignition Key Code Erase and Program
- (3): Program Additional Advanced Key
| Replacement part | M-MDS execution menu/sequence | Conditions |
|---|---|---|
| Keyless control module and PCM | (1) → (2) → (3) |
|