Pcm Configuration
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- If the wheel and tire sizes are changed, a discrepancy with the speedometer needle whereby it exceeds the allowable range could result in a malfunction. If the wheel and tire sizes are changed, perform the following procedure to change the tire size parameter setting. (See PARAMETER SETTING PROCEDURE WHEN TIRE SIZE IS CHANGED .)
- Connect the M-MDS (IDS) to DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS (IDS).
- "Module Programming"
- Select "Programmable Module Installation".
- Select menu in the "PCM".
- Perform the configuration according to the directions on the screen.
- Retrieve DTCs by the M-MDS (IDS), then verify that there is no DTC present.
- If a DTC(s) is detected, perform the applicable DTC inspection. (See DTC TABLE .)