Throttle position (TP) sweep inspection

Perform the KOER self test. (See KOEO/KOER SELF TEST .)
Verify that none of the following DTCs are displayed:
- P0122:00, P0123:00, P0222:00, P0223:00, P2100:00, P2101:00, P2107:00, P2108:00, P2119:00, P2122:00, P2123:00, P2127:00, P2128:00, P2135:00, P2138:00
  - If any one DTC is displayed, perform the DTC inspection. (See DTC TABLE .)
Access the APP1 and APP2 PIDs using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST .)
Switch the ignition to ON.
Verify the APP1 and APP2 PIDs when the accelerator pedal released and depresses.
Specification
- Accelerator pedal released:
  - APP1: Approx. 0.4 V
  - APP2: Approx. 0.4 V
- Accelerator pedal depressed:
  - APP1: Approx. 3.4 V
  - APP2: Approx. 3.4 V
- If not as specified, inspect for the following harnesses and connectors:
  - APP sensor terminal A-PCM terminal 1Q
  - APP sensor terminal B-PCM terminal 1Y
  - APP sensor terminal C-PCM terminal 1U
  - APP sensor terminal D-PCM terminal 1AV
  - APP sensor terminal E-PCM terminal 1AC
  - APP sensor terminal F-Main relay terminal C
    - If there is no malfunction, replace the accelerator pedal.