Headlight Auto Leveling System Initialization: Notes
CAUTION:
- If the headlight auto leveling initial setting is not stored correctly, the headlight auto leveling system may not operate normally. To store the initial setting correctly, perform the initial setting with the vehicle under the following conditions:
- No occupants inside vehicle
- Cargo other than spare tire, jack, and tools not loaded
- Tire pressure is at specification (See WHEEL AND TIRE SPECIFICATION .)
NOTE:
- The headlight auto leveling system initial setting has a procedure which uses the M-MDS and one which does not. Because the procedure differs depending on the part which is replaced in the method not using the M-MDS, refer to the following and perform the initial setting.
- If the following servicing is to be done, perform the procedure for the case where system initialization has never been done. (See INITIALIZATION HAS NEVER BEEN PERFORMED .)
- AFS (adaptive front lighting system) control module is newly replaced.
- If the following servicing is to be done, perform the procedure for the case where system initialization has never been done. (See INITIALIZATION HAS NEVER BEEN PERFORMED .)
- If the following servicing is done, perform the procedure for the case where the system is reset after initialization has already been completed. (See INITIALIZATION OPERATION IMPLEMENTED AND RESETTING TO BE PERFORMED .)
- Auto leveling sensor is removed/installed.
- Auto leveling sensor is replaced.
- Procedure for changing vehicle height is performed such as changing suspension.