Pinpoint Test 3: Transmission Control Switch (TCS) Does Not Operate Correctly

TRANSMISSION CONTROL SWITCH (TCS) DOES NOT OPERATE CORRECTLY - PINPOINT TEST 3

PINPOINT TEST 3		TCS DOES NOT OPERATE CORRECTLY
STEP	INSPECTION		ACTION
1	TEST THE INSTRUMENT CLUSTER (IC) Connect the scan tool. Using the scan tool, monitor the TCS PID while cycling the TCS. Does the TCS PID cycle from yes to no?	Yes	See SYMPTOM TROUBLESHOOTING CHART - INSTRUMENT CLUSTER .
1		No	GO to the next step.
2	CHECK SJB FUSE 30 (5A) Key in OFF position. Check Smart Junction Box (SJB) fuse 30 (5A). Is the resistance less than 5 ohms?	Yes	GO to the next step.
2		No	GO to step 4.
3	TEST THE TCS POWER CIRCUIT FOR AN OPEN Disconnect: Selector Lever Harness 0518-01. Disconnect: SJB fuse 30 (5A). Measure the resistance between the selector lever harness 0518-2096 pin 6, circuit (Y/L), harness side and the output side of SJB fuse 30 (5A). Is the resistance less than 5 ohms?	Yes	GO to step 5.
3		No	REPAIR circuit CBP30 (Y/L). RECONNECT all components. TEST the system for normal operation.
4	TEST THE TCS POWER CIRCUIT FOR A SHORT TO GROUND Disconnect: Selector Lever Harness. Disconnect SJB fuse 30 (5A). Measure the resistance between selector lever harness 0518-2096 pin 8, circuit (Y/L) and ground. Is the resistance less than 10,000 ohms?	Yes	GO to step 6.
4		No	REPAIR circuit (Y/L). TEST the system for normal operation.
5	TEST THE TCS SIGNAL CIRCUIT FOR AN OPEN Disconnect: PCM Transaxle C175B. Measure the resistance between the selector lever harness 0518-2096 pin 5, circuit (L/O) and PCM 0140-275B pin 27, circuit (BR/G). Is the resistance less than 5 ohms?	Yes	GO to step 7.
5		No	REPAIR circuit BR/G. RECONNECT all components. TEST the system for normal operation.
6	TEST THE TCS SIGNAL CIRCUIT FOR A SHORT TO GROUND Measure the resistance between selector lever harness 0518-2096 pin 5, circuit (BR/G) and ground. Is the resistance greater than 10,000 ohms?	Yes	GO to the next step.
6		No	REPAIR circuit (BR/G). TEST the system for normal operation.
7	TEST THE TCS Measure the resistance between selector lever 0518-2096 pin 5, circuit (B/G) and 0518-2096 pin 6, component side, while cycling the TCS Is the resistance less than 5 ohms when pressed and greater than 10,000 ohms when released?	Yes	INSTALL a new PCM. See PCM REMOVAL/INSTALLATION - 2.5L/3.0L . TEST the system for normal operation.
7		No	INSPECT the selector lever wiring harness for damage and REPAIR as necessary. If the selector lever wiring harness is not damaged, INSTALL a new selector lever knob. See SELECTOR LEVER REMOVAL/INSTALLATION . TEST the system for normal operation.