LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> RX-8 R3, 1.3 2 >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Quick Release Connector Removal/Installation >> Installation

Quick Release Connector Removal/Installation: Installation

NOTE:
  • If the quick release connector O-ring is damaged or has slipped, replace the quick release connector.
  • A checker tab is integrated with the quick release connector for new fuel hoses and evaporative hoses. Remove the checker tab from the quick release connector after the connector is completely engaged with the fuel pipe.
  1. Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.
    • If there is any malfunction, replace it with a new one.
  2. Apply a small amount of clean engine oil to the sealing surface of the fuel pipe.
  3. Reconnect the fuel hose straight to the fuel pipe until a click is heard.
    NOTE:
    • If the quick release connector dose not move at all, disconnect it, verify that the O-ring is not damaged or has not slipped, and then reconnect the quick release connector.
  4. Lightly pull and push the quick release connector a few times by hand, and then verify that it can move 2.0-3.0 mm {0.08-0.12 in} and is connected securely.
  5. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION .)
scientia non olet · About LEMON Manuals