LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> RX-8 R3, 1.3 2 >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> After Service Precaution >> Fuel Leakage Inspection >> Using M-MDS

Using M-MDS

  1. Connect the M-MDS to the DLC-2
  2. Using the simulation function "FP", start the fuel pump. (See ON-BOARD DIAGNOSTIC TEST [13B-MSP] .)
  3. Verify that there is no fuel leakage from the pressurized parts.
    • If there is leakage, replace the fuel hoses.
    • If there is damage to the seal on the fuel pipe side, replace the fuel pipe.

    Fuel Leakage 

    There shall be no leakage after 5 min. 

    Fig 1: Identifying DLC-2 Connector
    G05980971Courtesy of MAZDA MOTORS CORP.
  4. After reinstallation, repeat Step  1- 3 of the fuel leakage inspection.
scientia non olet · About LEMON Manuals