LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> RX-8 R3, 1.3 2 >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Starter Interlock Switch Inspection

Starter Interlock Switch Inspection

CAUTION:
  • Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing.
  1. Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .)
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] .)
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] .)
  4. Disconnect the starter interlock switch connector.
  5. Verify that the continuity is as indicated in the table using a tester.
    Fig 1: Starter Interlock Switch Continuity Chart
    G05984894Courtesy of MAZDA MOTORS CORP.
    • If the continuity is not as indicated in the table, replace the starter interlock switch.
    Fig 2: Identifying Starter Interlock Switch Connector Terminals
    G05984895Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals