DTC P0602:00: Notes
DTC P0602:00 (L3 WITH TC) DETECTION CONDITION AND POSSIBLE CAUSE
| DTC P0602:00 |
PCM programming error |
| DETECTION CONDITION |
- No configuration data in the PCM.
NOTE:
- If the "PCM CONFIGURATION" is successful, the PCM stores DTC P0602:00 and illuminates the MIL (System is normal). Clear DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
- MIL turns off after three drive cycles with no failure (DTCs remain in the PCM).
Diagnostic support note
- This is a continuous monitor (CCM).
- MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
- DTCs are stored in PCM memory.
|
| POSSIBLE CAUSE |
- Configuration has not been completed.
- PCM malfunction
|