LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> CX-7 s Touring, 2.3 L, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System [L5]) >> Knock Sensor (KS) Removal/Installation

Knock Sensor (KS) Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  3. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  4. Disconnect the KS connector.
  5. Remove the KS.
  6. Install in the reverse order of removal.
    Fig 1: Locating KS Connector And Bolt With Torque Specifications
    G06205261Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals