LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System [MZR 2.5]) >> Neutral Switch Inspection

Neutral Switch Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
  2. Disconnect the neutral switch connector. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
  3. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
  4. Inspect for continuity between neutral switch terminals A and B.
    NEUTRAL SWITCH SPECIFICATION

    Measured condition Continuity
    Rod pushed Continuity detected
    Except above No continuity
    Fig 1: Neutral Switch Terminals
    G07620718Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals