LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 i Touring, 2.0 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Entertainment System) >> Steering Switch Removal/Installation

Steering Switch Removal/Installation

WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable and wait for 1 min or more.
  2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .)
  3. Remove the steering wheel. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] .)
  4. Remove the screw.
    Fig 1: Identifying Steering Wheel And Screw
    G06732373Courtesy of MAZDA MOTORS CORP.
  5. Remove the wiring harness from the cover hook.
    Fig 2: Identifying Wiring Harness And Cover Hook
    G06732374Courtesy of MAZDA MOTORS CORP.
  6. Remove the cover tabs and pins from the steering wheel.
    Fig 3: Identifying Steering Wheel, Cover Tabs And Pins
    G06732375Courtesy of MAZDA MOTORS CORP.
  7. Remove the cover.
    Fig 4: Removing Steering Wheel Cover And Pin
    G06732376Courtesy of MAZDA MOTORS CORP.
  8. Disconnect the connector.
  9. Remove the screw.
    Fig 5: Identifying Connector And Screw
    G06732377Courtesy of MAZDA MOTORS CORP.
  10. Remove the steering switch pins from the steering wheel.
  11. Remove the steering switch.
  12. Install in the reverse order of removal.
    Fig 6: Identifying Steering Switch Pins And Steering Wheel
    G06732378Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals