LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 i Touring, 2.0 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Entertainment System) >> Condenser Removal/Installation >> 4SD

Condenser Removal/Installation: 4SD

WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Rear seat cushion (See REAR SEAT CUSHION REMOVAL/INSTALLATION .)
    2. Rear scuff plate (LH) (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Tire house trim (LH) (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    4. C-pillar trim (LH) (See C-PILLAR TRIM REMOVAL/INSTALLATION .)
  3. Disconnect the connector.
  4. Remove the bolt.
  5. Remove the condenser.
  6. Install in the reverse order of removal.
    Fig 1: Condenser, Connector And Bolt Torque Specifications Table (4SD)
    G06732338Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals