LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 i SV, 2.0 G >> Repair and Diagnosis >> External Pages >> Different car >> Section 573 (Engine Control System [L3 With TC]) >> Knock Sensor (KS) Removal/Installation

Knock Sensor (KS) Removal/Installation

WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be careful not to impact the sensor.
  • Verify that there is no debris between the sensor and the cylinder block before installing.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] .)
  2. Disconnect the negative battery cable.
  3. Remove the intake manifold. (SeeINTAKE-AIR SYSTEM REMOVAL/INSTALLATION )
  4. Disconnect the KS connector.
  5. Remove the KS.
  6. Install in the reverse order of removal.
    Fig 1: LS Connector With Torque Specifications
    G06730948Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals