LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 i SV, 2.0 F >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System [LF, L5] >> Clutch Pedal Position (CPP) Switch Inspection

Clutch Pedal Position (CPP) Switch Inspection

  1. Verify that the CPP switch is installed properly.
  2. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] ).
  3. Disconnect the negative battery cable.
  4. Disconnect the CPP switch connector. (See CLUTCH PEDAL REMOVAL/INSTALLATION ).
  5. Inspect for continuity between the CPP switch terminals using an ohmmeter.
    • If not as specified, replace the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION ).
      SPECIFICATION

      Measured condition Clutch pedal position Continuity
      Rod pushed Clutch pedal released Continuity detected
      Except above Clutch pedal depressed No continuity
      Fig 1: Identifying CPP Switch Connector Terminals
      G07868514Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals