LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System [LF, L5]) >> Engine Coolant Temperature (ECT) Sensor Removal/Installation >> ECT Sensor No. 1

ECT Sensor No. 1

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] ).
  2. Disconnect the negative battery cable.
  3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS ).
  4. Remove the battery and battery tray. (See BATTERY REMOVAL/INSTALLATION [LF, L5] ).
  5. Disconnect the ECT sensor No. 1 connector.
  6. Remove the ECT sensor No. 1 using the SST.
  7. Install in the reverse order of removal.
  8. Refill the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS ).
    Fig 1: Removing ECT Sensor No. 1 Using SST With Torque Specifications
    G07868517Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals