Generator Warning Light
- Verify that the battery is fully charged.
- Verify that the drive belt is correct. (See DRIVE BELT INSPECTION [L3 WITH TC] ).
- Switch the ignition to ON, verify that the generator warning light illuminates.
- If it does not illuminate, inspect the generator warning light and the wiring harness.
- If the generator warning light and the wiring harness are normal, inspect the PCM.
- If it does not illuminate, inspect the generator warning light and the wiring harness.
- Verify that the generator warning light goes out after the engine is started.
- If the generator warning light does not go out, perform the DTC inspection, then perform troubleshooting according to the corresponding diagnostic procedure. (See ON-BOARD DIAGNOSTIC TEST [L3 WITH TC] ). (See DTC TABLE [L3 WITH TC] ).