LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Keyless Receiver Inspection [Keyless Entry System] >> Notes

Keyless Receiver Inspection [Keyless Entry System]: Notes

  1. Remove the following parts:
    1. Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION ).
    4. Shift knob (MTX) (See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION ).
    5. Selector lever knob (ATX) (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION ).
    6. Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION ).
    7. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
    8. Console (See CONSOLE REMOVAL/INSTALLATION ).
  2. Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
  3. Remove the lower panel, (driver-side) (See LOWER PANEL REMOVAL/INSTALLATION ).
  4. Measure the voltage according to the terminal voltage table.
    • If the voltages cannot be verified as indicated in the Terminal Voltage Table (Reference)  , inspect the parts under "Inspection item (s)".
      • If the system does not work normally even though the parts or related wiring harnesses do not have any malfunction, replace the keyless receiver.
  5. Disconnect the negative battery cable.
scientia non olet · About LEMON Manuals