LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security System And Locks System >> Immobilizer System-Related Parts Programming [Advanced Keyless Entry And Push Button Start System] >> No. 4 Programming Procedure After Simultaneous Replacement of Immobilizer System-related Parts (PCM, Keyless Control Module) >> Notes

No. 4 Programming Procedure After Simultaneous Replacement of Immobilizer System-related Parts (PCM, Keyless Control Module): Notes

CAUTION:
  • The engine cannot be started if any step or procedure is skipped. Perform all procedures in the order of the steps.
NOTE:
  • If the keyless control module is replaced, complete the configuration before performing the following menu.
  • If the PCM is replaced, complete the configuration before performing the following menu.
  • When replacing the keyless control module, remove the valid keys and the valid advanced keys from the vehicle (keep them 1 m or more from the vehicle) and switch the ignition ON according to the directions on the M-MDS screen. Select, "There is no programmed ignition key and programmed advanced key" from the M-MDS screen.
CAUTION:
  • If the ignition is switched ON by selecting "FORCED IGNITION ON", the engine cannot be started.
  • Although the security light or the keyless warning light illuminates or flashes, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
CAUTION: M-MDS menu
  1. Parameter Reset
  2. Ignition Key Code Erase and Program
  3. Program Additional Advanced Key
Replacement part M-MDS execution menu/sequence Conditions
Keyless control module and PCM (1)→(2)→(3)
  • Have two or more keys to be programmed after the replacement.
  • Have one or more advanced keys to be programmed after the replacement.
scientia non olet · About LEMON Manuals